Model P5154 Series
ONE OR TWO DRUM FLOOR-MOUNTED
STATIONARY "ROTATORS"

MIX, BLEND, OR TUMBLE MATERIAL 
INSIDE CLOSED DRUMS

CLOSED DRUMS MEAN LESS HAZARDS

SAVE TIME, LABOR AND MONEY BY ELIMINATING
TRANSFER, CLEAN-UP, SPECIAL VESSELS AND APPARATUS INSURE HOMOGENEITY

Using a Morse Rotator Eliminates

• Spillage

• Splashing of dangerous contents on workers

• Risk of contamination

New uses for MORSE Drum Rotators are being discovered all the time. There is a good chance that a MORSE Rotator could be the solution to a problem in your plant.

MORSE MODEL P1-5154 DRUM ROTATOR  

• Powerful 1/2 hp motor drives an efficient worm gear reducer connected to a solid 1" (2.54 cm) diameter shaft to turn four 6" (15 cm) diameter Neoprene drive wheels

• Four idler wheels turn freely on roller bearings

• Factory fixed drum speed choices are 10, 20, 30, or 40 rpm

• Drum rolling speed of 20 rpm is good for most liquids

• 20 rpm will be furnished unless otherwise specified

• Base 24" x 55" (61 cm X 140 cm)

• Capacity:
  

MODEL P1-5154VS (not shown) 

• Similar to model P1-5154, but the transmission allows the user to vary the drum speed from 10 to 40 RPM

• Ideal for experimental use

• Some users prefer fast initial rolling and reduced speed for continued, gentle agitation

• Base 24" x 55" (61 cm x 140 cm)

MODEL P2-5154 DOUBLE DRUM ROTATOR - 
TWICE THE CAPACITY  

• Heavy-duty 1 hp motor drives an efficient gear reducer connected to a 1" (2.54) diameter shaft operating eight 6" (15.2 cm) diameter Neoprene drive wheels

• Four roller bearing idler wheels for each drum position

• Approximate Shipping Weight 465 Lb. (211 kg)

•  Speed choices same as for P1-5154 above

MODEL P1-5154VS AND P2-5154VS HAVE VARIABLE SPEED VERSIONS (not shown) 

• Designed to rotate drums at any speed from 10 to 40 rpm

• Speed is regulated easily by turning a knob

• Powerful motor with variable speed gear reduction will handle the same drum weights at corresponding speeds as the fixed speed models

• Base 24" x 97" (61 cm x 140 cm)

Install Morse Rotators in accordance with OSHA requirements for enclosure and interlock, etc. For OSHA compliance, see OSHA subpart O.1910.212 "General requirements for all machines." Power connections and motor controls must comply with applicable codes.