Model P300, and P305 Series
MIX, BLEND, TUMBLE CLOSED DRUMS
MORSE "ROTATORS"

END-OVER-END TUMBLERS

MODEL P1-300 ENDOVER ROTATOR

TURNING THE DRUM END OVER END PROVIDES MORE AGGRESSIVE MIXING ACTION

• Mix in closed shipping drums 

• Save time, labor and money 

• Eliminate transfer, clean-up, special vessels and apparatus

• End-over-end tumbling action does a thorough mixing job

• Mix dry powders and wet grains, dyes and coloring liquids, fine and coarse granules, settled liquids and powders

• Ideal for mixing highly viscous substances inside closed drums

• Put valuable ingredients back into suspension

• Less residue left in drums, making them less costly to clean or dispose of

• Sturdy frame is built to resist the stress and shock of tumbling load

• Standard motor is 1 HP 230V 3-Phase

• Standard electric control includes start, stop and jog functions

• Other motor voltages, explosion proof motors, and air motors available

• Drum speed: 13 rpm

• Capacity: 800 lb. (363 kg) gross load in standard 55 gallon (210 litre) drum

• Base dimensions: 30" x 56" (76 cm x 142 cm)

• Shipping weight: 600 lb. (272 kg).

OPTIONAL EQUIPMENT: 
Loading crane for self-contained loading capability.

MODEL P2-300 ROTATES TWO DRUMS SIMULTANEOUSLY

MODEL P305 SERIES CAN TUMBLERS
MIX OR TUMBLE SMALL BATCHES QUICKLY AND ECONOMICALLY

• Mix inside closed 5 gallon cans, one or two at a time, without special added equipment

• Mix, blend, agitate liquid or dry materials or tumble parts with media for polishing or deburring

• Cans are held at angle to the horizontal rotating shaft resulting in "corner-over-corner" mixing action

• Use of ordinary cans can be an economical alternative to special mixing vessels

• Keeping the lid in place while agitating can reduce hazards and save clean-up

• When materials to be agitated are already packed in cans, savings can be exceptional

• No costly transfer, no clean-up, no hazards or expense of exposure to the product and possible spills

MODEL P2-305 TUMBLES TWO FIVE GALLON CANS

• Hand wheel and threaded rod with locking handle provide quick, secure clamping action holding can closed and in place during rotation

• Accepts cans up to 12-½"(31 cm) diameter 

•  4-1/2 to 16-½" (12-42 cm) tall, including typical 5 gallon cans

• Model P1-305 (shown above) has same frame and drive as P2-305, but one can holder instead of two

• Tumbling speed factory set at 23 RPM

• Motor is 1/4 HP in a choice of voltages, phases, TEFC or explosion proof

• Air motors are also available

• Single phase, 115V TEFC version (P2-305-1, or P1-305-1) includes 60 minute timers for automatic shut-off

• Timers not included with other motor choices

Install Morse Rotators in accordance with OSHA requirements for enclosure and interlock, etc. For OSHA compliance, see OSHA subpart O.1910.212 "General requirements for all machines." Power connections and motor controls must comply with applicable codes.